Never a Dull Blade
The R'S Prints blade sharpening jig makes sharpening your profiling blades easy. Place the blade into the jig, run it over your sharpening stone, and voila - like new.
Set up is simple:
place a piece of paper underneath the wheels, then place the blade so that it is touching the sharpening stone. Tighten the screw and the angle is all set.
Remove the piece of paper then run the jig over the stone several times until you see an even reflective surface on the bottom of the blade. This indicates that the blade has been properly sharpened.
Take the blade off the jig and place the flat side on the sharpening stone. After 3-5 to passes to remove the burr, and the blade is ready to go.
- Weight
- 17 g
- Size
- 6 × 4 × 2 cm
- Manufacturer
- Reeds 'n Stuff
- Country of origin
- Germany
- Product number
- 1299-001041299-00104
- Legal Guarantee
- According to German consumer protection laws, consumers are entitled to request, free of charge, that the seller repair or replace goods that are defective or do not conform to the purchase contract. Alternatively, consumers may be entitled to a price reduction or a refund of the purchase price. These rights apply for a period of two years from the date the goods are delivered to the consumer. For more information, please click
here.