Simply adjust the blade of your Profiling Machine with our new Blade Adjustment Indicator.
52 Clock Face
57 Measuring Pin
24 Blade Set Screw
25 Blade Adjustment Srew
Before you begin take off the machines wooden handle and take out the blade. Then fit the dial indicator over the carriage as pictured.
Tighten the large screw on the dial indicator to secure it.
Turn the clock face as needed to set the dial indicator to zero.
Place the blade in the carriage as pictured. As you slide the blade into place, the slot in its side should fit with the corresponding ledge on Screw #25. It is important to confirm that, at this point, the blade does not protrude beyond the black blade holder.
Tighten Screw #24 all the way, so that the blade is held completely in place. Then, gently loosen it about less than a quarter of a turn, until the blade can be moved very slightly.
Turn Screw #25 until the dial indicator reads precisely 2,5 till 3. At this point, the blade will be protruding to the correct degree.
Tighten screw all the way. The machine is now ready to use. Before you start using the machine make sure the blade does not touch the tongue. See instructions in chapter: thicker results.
As you remove the dial indicator from the carriage, be sure to pull up on the axle of the dial indicator as shown to avoid any damaging contact with the blade.